The screed operator's ErgoBasic console

Automatic:

In automatic mode, conveyor speed is controlled by the filling level sensors. Automatic mode is only available in “Pave” mode.

Manual:

When the button is pressed, the conveyor runs at top speed after a brief delay. The conveyor stops when the button is released.

The warning signal sounds when the button is pressed.

Automatic:

In automatic mode, auger speed is controlled by the filling level sensors. Automatic mode is only available in “Pave” mode.

Conveying capacity:

Use the + or - button to reduce/increase the conveying capacity (specified value) of the augers.

Manual:

When the button is pressed, the half of the auger on the side of the operating console runs at full speed.

Reversing:

When the button is pressed, the half of the auger on the side of the operating console reverses at moderate speed.

When the button is pressed, Screed Float is switched on. This button is used when setting up the screed or to deactivate the automatic Screed Hold function.

When the button is pressed, the screed tow point ram on the side of the operating console is raised/lowered.

When the button is pressed, the screed extension on the side of the operating console is moved to the left or right.